Franke Kaffeemaschinen AG Decommissioning | 13
User manual SB1200 FM CM 85
13 DECOMMISSIONING
13.1 Preparing for decommissioning
1. Clean the machine using the automatic cleaning
function.
2. Empty the bean hopper and powder hopper.
3. Clean the bean hopper and powder hopper.
4. Clean the grounds container.
5. Clean the spout cleaning device.
6. Empty the container.
7. Clean the container and container lid.
8. Clean the cleaning container.
9. Clean the plug-in couplings.
10. Clean the inside of the suction hose and the suc-
tion nozzle using a brush.
11. Clean the inner surfaces of the cooling chamber.
12. Clean the inner side of the door and the door
profile gasket.
13.2 Short-term decommissioning (up to 3 weeks)
ü The machine remains in place.
1. Clean the machine using the automatic cleaning
function.
Cleaning [
}
53]
2. Enable the energy-saving mode.
3. Disconnect the machine from the power supply.
4. Close the water supply if the machine has a
mains water connection.
5. Clean any add-on units.
6. Switch off the add-on units and disconnect them
from the power supply.
13.3 Long-term decommissioning
NOTICE
Functionality of the machine is impaired in the event of long-term decommissioning and storage
If you plan to start using your machine again at a later date, it is essential service measures are implemented. The
coffee machine must be maintained, installed, and cleaned before preparing any drinks.
a) Contact the Franke Service team for information regarding proper decommissioning and storage.
b) Have your coffee machine drained by your service technician.
c) Remedial maintenance may be required when commissioning the machine if it has been stored in excess of 6
months.
13.4 Transport and storage
Protect the machine from mechanical damage and adverse environmental conditions during transport and storage.
Protect the machine against the following:
– Vibrations
– Dust
– Sunlight
– Falling or tipping over
– Slipping during transport
To Next Page
Loading...
