EasyManua.ls Logo

Franke SAPHIRA - 8 Adjustment of the Grinder; 9 Water Hardness Setting

Franke SAPHIRA
61 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Instruction for use Saphira Page 41 18.06.04 / Rev D / Maks 4 / PPB
8. Adjustment of the grinder
You can adapt the grinder to the degree of roasting of your coffee. We recommend:
dark roast finer setting
light roast coarser setting
To adjust the degree of grinding, turn the adjusting rings to the desired position (Fig.1)
You have the following possibilities:
The smaller the dots, the finer the grinding
The larger the dots, the coarser the grinding
The degree of grinding may be adjusted only with the grinder running.
9. Water hardness setting
Water is heated in the appliance. This leads to limescale during use, which is automatically indicated on
the display. The Unit must be adjusted to the hardness of the water used. Use the test sticks supplied.
1° German hardness corresponds to 1.79° French hardness.
The Unit has 5 hardness levels:
WATER HARDNESS
LEVEL -- Water hardness function switched off
WATER HARDNESS German water hardness 1 -
LEVEL 1 French water hardness 1.79 12.53°
WATER HARDNESS German water hardness 8 - 15°
LEVEL 2 French water hardness 14.32 - 26.85°
WATER HARDNESS German water hardness 16 - 23°
LEVEL 3 French water hardness 28.64 - 41.14°
WATER HARDNESS German water hardness 24 - 30°
LEVEL 4 French water hardness 42.96 - 53.7°
The Unit has been set to level 3 at the factory. You can change the setting. To do this, proceed as
follows:
Switch on the Unit at the ON/OFF button (23).
Display: PLEASE
WAIT
Press the PROG. button (26) until an acoustic signal is heard.
Display: ADJUST
COFFEE QTY.
Display: SELECT
PRODUCT
Press the + button (27) until the following message appears:
Display: WATER HARDNESS
LEVEL 3
Press the PROG. Button (26); an acoustic signal is heard and the set level flashes.
You can set the desired level by pressing the (28) or + (27) button. To save the setting, press the
PROG. button (26). An acoustic signal is heard.
Display: WATER HARDNESS
LEVEL 3
Press the EXIT button (30).

Table of Contents

Related product manuals