FIGURE A
FIGURE B
CLOSING THE ECLIPSE
• Ensure the Slider Car wing shaped
inclination stop pin (20) is disengaged
(pulled out) and in a vertical position with
the steel pin lying horizontal in the slot
(Figure A). You may need to take some
tension off the umbrella canopy to set
the pin to vertical. Do this by rotating the
Winder Handle (30) in a counter-clockwise
direction.
• Rotate the Winder Handle (30) in a
counter-clockwise direction. First the
canopy will collapse and then the slider
car (19) will descend down the mast.
• The lowering of the slider car may be
assisted manually if required.
• Put the canopy strap securely around both
the mast and canopy frame.
• Fold the canopy neatly to safeguard any
“pinching” of the canvas within the umbrella
frame. This is easily done by pulling the
canvas to the outside of the frame using
your hands to pull the excess in each of
the 8 sections of the frame. Then fold each
section of fabric left over right etc.
• Fit the cover bag over the mast and frame
and zip up (Figure B).
| 8
To Next Page
Loading...
