We suggest you purchase the lubricant from our local distributors or contact our company directly.
Note: For other maintenance, please get a specialized person to operate.
1
．
To have a better maintenance over the treadmill and prolong its life, we suggest you power off for
ten minutes in every two hours.
2
．
Loose belt will result in sliding while running, while too tight shall decrease the motor performance
and create more friction between the roller and running belts. The most suitable tightness of the belts
would be: the belts can be pulled out 50-75mm away from the running boards.
WALKING BELT CENTERING AND TENSION ADJUSTMENT
DO NOT OVERTIGHTEN the walking belt.
This may cause reduced motor performance and excessive
roller wear.
TO CENTER WALKING BELT:
● Place treadmill on a level surface
● Run treadmill at approximately 3.5 mph
● If the belt has drifted to the right, turn the right adjusting bolt 1/2 turn clockwise and the left adjusting
bolt 1/2 turn counterclockwise
● If the belt has drifted to the left, turn the left adjusting bolt 1/2 turn clockwise and the right adjusting
bolt 1/2 turn clockwise and the right adjusting bolt 1/2 turn counterclockwise
Picture A If the belts has drifted to the RIGHT
Picture
B
If the belts has drifted to the LEFT
WARNING: ALWAYS UNPLUG THE TREADMILL FROM THE ELECTRICAL OUTLET BEFORE
CLEANING OR SERVICING THE UNIT.
PIC A
PIC B
To Next Page
Loading...
