a: Please check the wire from motor, please connect the wire well; If this is no problem
with wire connection, please change a new motor.
b: Please is there bad smell from the control board, if the IGBT is shorted out, please
change a new driver;
c: Please make sure the voltage is in normal condition.
4.E03 display: No signal
a: If the E03 is displayed after start of 5 to 8 seconds, this is the failure of signal, please
check the connection of sensor is well. If it is not connected well, please connect again. If
the sensor do not work well, change a new sensor;
b: The signal in control board is wrong, please change a new driver;
5.E04 display: The failure of incline
a: Please check the signal wire of incline motor is connected well;
b: Please check the AC line of incline motor is connected to the right slot;
c: Please check the wire of incline motor, change a new wire or a new incline motor.
d: Please change a new driver;
e: If are wires are connect well, please reset the button on the driver and start again.
6.E05 display: Over load current protect
a: May be the current is too strong, the system protect itself, please restart the machine.
b: May be a part of the machine is locked and result in the motor problem, please add the
oil to the machine and restart.
c: Please check if there is bad smell from the motor, if there is, please change a new
motor;
d: Please check if there is bad smell from the driver, if there is, please change a new
driver;
7. Can not start the machine: After press the start button, the time is counting, but the
motor can not work, and there is no error number showed on screen.
a: Please check the wire in motor is connected well;
b: Please the safety pipe on the driver, if it is broken, change a new one.
c: Please check the IGBT on the driver, if it is broken, change a new IGBT or a new driver.
To Previous Page
Loading...
