Servo Introduction
2000 µs(_
A
W
u
g
c
g
1000ų
2000ų
,
c
ck
,
'
I
c
u
c
ck
,
'
If you decide to purchase another brand of servo,
use the following list to ensure the servo has the
correct dimensions and cable length.
1
100mm
2
450mm
3
450mm
4
300mm
5
300mm
6
250mm
7
300mm
8
200mm
B
attery Installation
-
-9-
EN
1.
Use Y-harness to connect the No.1 and No.8 servos.
2.
Use Y-harness to connect the No.2 and No.3 servos.
3.
Use Y-harness to connect the No.4 and No.5 servos.
4.
Use Y-harness to connect the No.6 and No. 7 servos.
Our standard recommended batteries are:
45 14.SV 4000mAh 35C
or
65 22.2V 3700mAh 35C
The recommended battery capacity and discharge rate is :
4514.8V 3200mAh ~ 4S 14.BV 4500mAh
65 22.2V 3200mAh ~ 65 22.2V 4500mAh
Discharge rate of C 25C
Different battery weights may affect the CG. Be aware of this
and adjust to battery position to attain the correct CG.
Battery hatch
to remove
To remove the battery hatch, pull up on the tape as shown in
the diagram. Place the battery on the battery mount and
secure it using the Velcro straps. Check your CG. Ensure
that the radio is turned on and that throttle is in the lowest
position. Engage the kill switch if one is assigned.
Bat
tery hatch size:
To Next Page
Loading...
