Fresenius Medical Care bibag 508213 User Manual (English)

Questions and Answers:

J
Jacob CoxSep 6, 2025
What to do if bibag conductivity sensor error appears on Fresenius Medical Care bibag 508213 Medical Equipment?
- L
  lwestSep 6, 2025
  If the bibag conductivity sensor is not reading the correct conductivity, insert the blue bicarbonate connector into an appropriate liquid bicarbonate source. Or to use the bibag disposable: If during treatment, rinse back the patient’s blood and disconnect the patient from the machine. Run a Rinse program until message is cleared. If the alarm is not cleared, take the machine out of service and alert a qualified service technician.
S
Sonya BestSep 6, 2025
What to do if bibag Select Conc 45x appears on Fresenius Medical Care bibag 508213 Medical Equipment?
- C
  Curtis ThomasSep 6, 2025
  If the operator has attempted to start dialysis using the bibag system and an acid concentrate other than 45x is selected in Service Mode, bibag dialysis is compatible only with 45x acid concentrates. Either, restart the machine and enter Service Mode and select a 45x acid concentrate before beginning dialysis; Or use liquid bicarbonate for dialysis by inserting the blue bicarbonate connector into an appropriate liquid bicarbonate source.
P
Priscilla SmithSep 5, 2025
What to do if bibag bicarbonate pump is locked on Fresenius Medical Care bibag 508213 Medical Equipment?
- J
  Jill WeissSep 5, 2025
  If the bicarbonate pump has been air locked for over two minutes, if during treatment, rinse back the patient’s blood and disconnect the patient from the machine. Run a Rinse program to clear the alarm. If the alarm is not cleared, take the machine out of service and alert a qualified service technician.
D
Daniel CarterAug 25, 2025
What to do if the bibag door is open on my Fresenius Medical Care bibag 508213?
- J
  Joseph ChandlerAug 25, 2025
  If the bibag door is open, close the bibag door to continue.
M
Mark WilkersonSep 3, 2025
What to do if blood is sensed when emptying bibag on Fresenius Medical Care bibag 508213 Medical Equipment?
- A
  Autumn LeeSep 3, 2025
  If the operator has selected the Empty bibag button when blood is sensed, and the treatment is not yet finished and the bag must be changed, lift up on the bibag door, wait 30 seconds to relieve the pressure, and remove the bag. Put a new bag on the connector and close the door again to continue using the bibag system for the treatment.
W
Wendy HarringtonSep 2, 2025
What to do if bicarbonate venting is too long on Fresenius Medical Care bibag 508213?
- S
  Steven BakerSep 2, 2025
  If the bibag system has been venting longer than ten minutes when using the blue bicarbonate connector for liquid bicarbonate, press the RESET key to clear the message. If the alarm persists, turn machine power off and back on. If alarm is not cleared, return the blood to the patient if alarm occurs during treatment. Take the machine out of service and alert a qualified service technician.
A
Angel KempSep 1, 2025
What to do if bibag has been venting too long on Fresenius Medical Care bibag 508213?
- D
  debra00Sep 1, 2025
  If the bibag system has been venting longer than ten minutes, press the RESET key to clear the message. Pull the blue bicarbonate connector out of its port and then firmly plug it back in. If the message persists, rinse back the patient’s blood and disconnect the patient from the machine. Take the machine out of service, and alert a qualified service technician.
B
Becky HoffmanAug 31, 2025
What to do if bibag pressure is too low on Fresenius Medical Care bibag 508213 Medical Equipment?
- D
  David GeorgeSep 1, 2025
  If the pressure inside the bibag disposable is below the set alarm limits, open the bibag door, wait 30 seconds to relieve the pressure, and remove the bag. Place the bag back on the connector and close the door. If the alarm is not cleared: * Discontinue use of the bibag system. * Insert the blue bicarbonate connector into an appropriate liquid bicarbonate source in order to continue the treatment. * Alert a qualified service technician.
D
Danielle MasonAug 31, 2025
What to do if bibag pressure is too high on Fresenius Medical Care Medical Equipment?
- B
  Brenda VillaAug 31, 2025
  If the pressure inside the bibag disposable is above the set alarm limits, open the bibag door, wait 30 seconds to relieve the pressure, and remove the bag. Place the bag back on the connector and close the door. If the alarm is not cleared: * Discontinue use of the bibag system. * Insert the blue bicarbonate connector into an appropriate liquid bicarbonate source in order to continue the treatment. * Alert a qualified service technician.
G
georgejoseAug 30, 2025
What to do if bibag bag has been emptying too long on Fresenius Medical Care Medical Equipment?
- M
  Michael WrightAug 30, 2025
  If the bag has been emptying longer than five minutes, make sure that the blue bicarbonate connector is firmly plugged into the bicarbonate port. If the message is not cleared, remove bag without emptying and alert a qualified service technician.

Fresenius Medical Care bibag 508213 Specifications

Monitoring Dialysate

conductivity average accuracy	± 1.5%
conductivity alarm window adjustment at 40 mEq/L	±0.2 mS/cm
conductivity alarm window adjustment at 35 mEq/L	±0.1 mS/cm

Operating Environment