Fresenius Medical Care bibag 508213 User Manual (English)

Questions and Answers:

T
theresamaldonadoAug 29, 2025
What to do if bibag bag is on during cleansing/disinfecting program or using acetate with Fresenius Medical Care bibag 508213 Medical Equipment?
- E
  Ellen DavisAug 29, 2025
  If the bag is on the connector when user is either attempting to run a cleansing/disinfecting program or using acetate, remove the bag from the bibag connector if using acetate or attempting to run a cleansing/disinfecting program. Or Plug the blue bicarbonate connector back into the bicarbonate port on the machine.
T
Terry MendezAug 29, 2025
What to do if RO water conductivity is high on Fresenius Medical Care bibag 508213?
- C
  carolinewilsonAug 29, 2025
  If the Reverse Osmosis (RO) water inlet conductivity is too high, press the RESET key to clear the message. Perform a Rinse cycle. If alarm is not cleared, take the machine out of service and alert a qualified service technician.
C
Cassidy QuinnAug 27, 2025
What to do if bicarbonate conductivity is high on Fresenius Medical Care bibag 508213?
- J
  Joseph AriasAug 27, 2025
  If the actual or measured sodium bicarbonate concentrate conductivity has exceeded the high conductivity alarm limit when using the blue bicarbonate connector for liquid bicarbonate, wait five minutes for conductivity to stabilize. If the appropriate conductivity cannot be reached, make sure that the correct bicarbonate source is connected. If the alarm is still not cleared, rinse back the patient’s blood, and disconnect the patient from the machine. Take the machine out of service, and alert a qualified service technician.
G
gmillerAug 26, 2025
What to do if bibag conductivity is high on Fresenius Medical Care Medical Equipment?
- T
  Tyler PenningtonAug 26, 2025
  If the actual or measured bibag conductivity has exceeded the high conductivity alarm limit when using the bibag disposable, wait five minutes for conductivity to stabilize. If the appropriate conductivity cannot be reached, connect a new bag. If the alarm is still not cleared, return blood to the patient. Take the machine out of service and alert a qualified service technician.
K
Kaylee WilliamsAug 25, 2025
What to do if bibag bag leak on Fresenius Medical Care bibag 508213?
- S
  Shane MartinAug 26, 2025
  If a leak has been detected in the bag, open the bibag door, wait 30 seconds to relieve the pressure, and remove the bag. Place a new bag on the connector and close the bibag door.
S
Stephanie HudsonAug 25, 2025
What to do if there is no bag on bibag connector of Fresenius Medical Care bibag 508213 Medical Equipment?
- V
  vrodriguezAug 25, 2025
  If there is no bag on the connector, place a bag on the bibag connector and close the door to continue.

Fresenius Medical Care bibag 508213 Specifications

Monitoring Dialysate

conductivity average accuracy	± 1.5%
conductivity alarm window adjustment at 40 mEq/L	±0.2 mS/cm
conductivity alarm window adjustment at 35 mEq/L	±0.1 mS/cm

Operating Environment