38
W
arning messages/Info:
Text in Display Instruction/Remedy
Attention: Second If a fitting is to be fused
fusion process twice, the contact plugs
on the fusion unit of the
fitting must be pulled out
after the first fusion, and the
fitting must be allowed to
cool down (see processing
instructions by fitting
manufacturers).
Please read in Only with prime eco:
fusion code first this appears when the
traceability barcode of
a fitting was accidentally
read in first.
Please read in Only with prime eco:
valid traceability if e.g. the fusion barcode
barcode first of the fitting was
accidentally read in.
Please read in Only with prime eco:
valid operator pass this appears when the
operator pass needs to be
read in (e.g. when a unit is
blocked) and/or a different
(wrong) barcode is read in.
Please read in Only with prime eco:
valid commission this appears when the
number commission number needs
to be read in (e.g. when the
unit is set to reading in before
each fusion) and/or a faulty
input takes place or a
different (wrong) barcode
is read in.
Printer not ready Only with prime eco:
check if output unit
(PC/Laptop with FRIATRACE
from version 5.1, FRIATEC
Memory-Stick, printer) is
properly connected. If an
error message cannot be
resolved please contact the
FRIATEC Service Hotline:
+49 (0) 621 486 1533.
FT_2377e_II_07_GB.qxd 13.02.2007 12:31 Uhr Seite 38
To Next Page
Loading...
