29 PB
OPERATION
Remote Control Description
Pressing CLOCK button,
Press this button to turn on the unit .Press this button again to turn off the unit.
Press this button to decrease set temperature. Hold it down for 2 seconds or more to rapidly decrease set temperature. In AUTO mode,
set temperature is not adjustable.
Press this button to increase set temperature. Hold it down for 2 seconds or more to rapidly increase set temperature. In AUTO mode, set
temperature is not adjustable.
This button is used for setting Fan Speed in the sequence that goes from AUTO, to , to , , to , then back to Auto.
seconds increases or decreases the time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During
blinks. Within 5 seconds, pressing
+ or - button adjusts the present time. Holding down either button above 2
blinking after setting, press CLOCK button again to confirm the setting, and then will be constantly displayed.
, is sent out, the unit will carry out the command as indicates the This remote controller is universal. If any command
guide louver swings as:
. or
Low speed
Medium speed
High speed
Each time you press this button, a mode is selected in a sequence that goes from AUTO, COOL, DRY, FAN, and HEAT , as the following:
AUTO COOL DRY FAN HEAT
Note: Only for models with heating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not be displayed on the LCD, and the unit will
automatically select the suitable operationn mode in accordance with the room temperature to make indoor room comfortable.
Press this button to turn on SENSOR(SAVE) function. Saves room ambient temperature and automatically adjusts maintaining that
room ambient until pressed again which cancels the SENSOR(SAVE) function.
Press this button to initiate the auto-ON timer. To cancel the auto-timer program, simply press this button again.
After pressing this button, disappears and " ON " blinks.
00:00 is displayed for ON time setting. Within 5 seconds, press or button
to adjust the time value. Every press of either button changes
the time setting by 1 minute. Holding down either button rapidly changes
the time setting by 1 minute and then 10 minutes. Within 5 seconds after setting, press TIMER ON button to confirm.
Press this button to set up & down swing angle, which circularl
y changes as below:
Pressing EXTEND button in COOL or DRY mode, the icon is displayed and the indoor fan will continue operation for 10 minutes in
order to dry the indoor unit even though you have turned off the unit.
After energization, EXTEND OFF is defaulted. EXTEND is not available in AUTO, FAN or HEAT mode.
By pressing this button you can display the indoor setting temperature or indoor ambient temperature.When the indoor unit is first
powered on it will display the setting temperature. If the temperature's display status is changed from other status to" ",
it displays the
ambient temperature within 5 seconds. If another remote signal is received, it will return to display the setting temperature. If the
users haven't set up the temperature displaying status, it will display the setting temperature. (This function is not applicable
for some models).
Press this button to initiate the auto-off timer. To cancel the auto-timer program, simply press the button again.TIMER OFF setting is the
same as TIMER ON.
Auto
(horizontal louvers
stops at current position)
no display
To Next Page
Loading...
Need help?
General
