Remote control battery
To use the remote control, it is
necessary to install two (R03/Ir03x2)
alkaline AAA batteries.
When should the batteries be
replaced
1. When there is not a "beep"
anymore from the indoor unit when
using the control remote or the
signal light indicator does not lit.
2. The indoor unit does not respond
to the remote control commands to
activate the programs.
conditioner emits a "beep" that
indicates that a command has been
received and transmitted in the
indoor unit.
3. When selecting the function of
timer, the remote control sends
(automatically) a signal to the indoor
unit at the specific moment. If the
control remote is left in a position
that the signal is blocked, a 15
minute delay can be produced.
To replace batteries
1. Slide out the battery compartment
cover ( located in the back part of
the remote control).
2. install the two AAA batteries in the
compartment (indicated in the
drawing located inside the
compartment).
3. Slide in the cover.
4. If the remote control is not
operated for long period of times,
batteries should be discarded.
Remote control instructions
1. The signal reach distance of the
remote control to the receiver that
is inside the main unit of the air
conditioner is 8 meters. Any
obstruction placed between the
receiver and the remote control can
cause interference, limiting the
capacity of the programming.
2. Any time that a button is pressed
in the remote control, the air
Attention
1. When replacing batteries, do not
use old batteries or a different type
battery. This may cause the remote
control to malfunction.
2. If you do not use the remote
controller for several weeks remove
the batteries. Otherwise battery
leakage may damage the remote
controller,
3. The average battery life under
normal use is about 6 months,
4. Replace the batteries when there is
no answering beep from the indoor
unit or if the Transmission indicator
light fails to light.
To Next Page
Loading...
