Solutions for problems
If your air conditioner malfunctions, check the following information to find
solutions or probable causes of the failure. Do not try to repair the unit by
yourself, if these solutions do not solve the failures; call your local service repair
team.
Poor Equipment performance
1. The air outlet or inlet in the exterior part is obstructed,
2. The temperature in the exterior is high due to direct sunlight or another heat
source.
3. Heater or a cooking stove is being used in the same room.
4. Room is full of people.
5. The air filter is obstructed by dust or is dirty.
6. Inappropriate temperature adjustment,
7. Front part is obstructed.
8. The capacity of the equipment is not adequate for the size of the room.
9. Air conditioner was just turn on.
10,Windows or doors are open.
11.Motor protector has been activated.
The unit does not start
1. The plug is not connected to the outlet.
2. No electricity in the outlet.
3. The voltage is different.
4. Temperature is not adjusted properly.
5. burned fuse,
6. The remote control batteries need to be replaced.
7, wrong operation time.
Attention
Stop the air conditioner immediately if one of the following malfunctions occur
1. The operation indicator or other indicator flash(5times per second) and the flashing is
not stop by disconnecting and connecting the unit,
2. Frequentchange of fuses and malfunctions in the switch circuit.
3. Water spills over the equipment,
4. Remotecontrol does not work,
5. Any other abnormal situation,
®
To Next Page
Loading...
