The AIR DIRECTION and SWING buttons
will be disabled when the air conditioner
is not in operation (including when the
TIMER ON is set).
Do not operate the air conditioner for
long periods with the air flow direction set
downward in cooling or dry mode.
Otherwise, condensation may occur on
the surface of the horizontal louver
causing moisture to drop on to the floor
or on furnishings.
Do not move the horizontal louver
manually. Always use the AIR DIRECTION
or SWING button. If you move this louver
manually, it may malfunction during
operation, If the louver malfunctions, stop
the airconditioner once and restart it.
When the air conditioner is started
immediately after it was stopped, the
horizontal louver might not move for
approximately 10 seconds.
Open angle of the horizontal louver
should not be set too small, as COOLING
or HEATING performance may be
impaired due to too restricted air flow
area.
Do not operate unit with horizontal louver
in closed position.
When the air conditioner is connected to
power (initia_ power), the horizontal louver
may generate a sound for 10 seconds,
this is a normal operation.
To Next Page
Loading...
