Froling S3 Turbo User Manual

4.1 General fault with power supply 29
4.1.1 Behaviour of system after a power failure 29
4.2 Excessive temperature 29
4.3 Faults with fault message 30
4.3.1 Procedure for fault messages 30
4.3.2 Acknowledging a fault message 30
5 Boiler Servicing 31
5.1 General information on servicing 31
5.2 Inspection and cleaning 32
5.2.1 Prior to heating up 32
Always move the WOS lever 32
5.2.2 Inspection 32
Checking the system pressure 32
Checking the thermal discharge safety device 33
Checking the safety valve 33
5.2.3 Cleaning 33
Removing ash 33
Clean the grating 34
Clean the heat exchanger pipes 35
5.2.4 Annual inspection 37
Cleaning the flue gas temperature sensor 37
Cleaning the carbonisation gas duct 37
Checking the primary air openings 38
Check the seal on the doors 39
Cleaning the flue gas pipe 40
Checking the draught controller flap 40
Cleaning the induced draught fan 40
5.3 Emissions measurement by chimney sweep or regulatory body 41
5.3.1 Preparing for the measurement 41
5.3.2 General information on measurement 41
5.3.3 Performing the emissions measurement 42
Preparing for the measurement 42
Create the measurement conditions and perform the measurement 42
5.4 Maintenance agreement / Customer service 43
5.5 Replacement parts 43
5.6 Disposal information 44
5.6.1 Disposal of the ash 44
5.6.2 Disposal of system components 44
6 Appendix 45
6.1 Addresses 45
6.1.1 Address of manufacturer 45
6.1.2 Address of the installer 45
Table of contents
Operating Instructions S3 Turbo | B0610717_en 3

Froling S3 Turbo Specifications

General

Brand	Froling
Model	S3 Turbo
Category	Boiler
Language	English