Fromm Dynamic 2100 - Page 15

Dynamic 2100 Battery Strapping Tool Operation Manual | FPA001 | Apr 2018 | Page 13
Tool Trouble
Possibilities
Solution
Tool badly cuts the strap
or doesn’t cut at all
Cutter is worn or damaged
Replace cutter
Faulty adjustment of the
coupler
Check the adjustment and
readjust if necessary
Welding gripper is worn
Replace welding gripper
Welding time too short
Change adjustment
(See 3.2)
Defective pressure spring
N2.5237/82
Replace pressure spring
Tool switches off after a
few strappings (displaying
empty battery)
Battery defective or empty
Check the battery and
change defective batteries
Gear noise
Tensioning or welding
gear is worn
Check component parts
and replace defective
ones