Fromm P328 - User Manual

Questions and Answers

H
hughesaaronAug 9, 2025
How to troubleshoot a Fromm P328 that doesn’t work at all?
- J
  Jonathan ManningAug 9, 2025
  If your Fromm Packaging equipment isn't working, there could be several reasons: * The battery might be empty or defective, in which case you should charge or replace it. * There could be contact problems due to a broken battery housing, requiring battery replacement. * Damaged parts like insertation part N51.2194 or motor housings P32.8103 and P32.8105/96 could cause contact issues, necessitating their replacement. * Internal wire contact problems may exist, requiring contact checks and fixes or defective part replacements. * A defective circuit board might be the cause, requiring its replacement.
X
xbrownAug 28, 2025
Why does the tensioning wheel turn back immediately after tensioning cycle in Fromm P328 Packaging equipment?
- D
  Daniel GlassAug 28, 2025
  If the tensioning wheel on your Fromm Packaging equipment turns back immediately after the tensioning cycle, it might be due to a defective needle free wheeling N3.4509 in P32.8134. Check these parts and replace them if necessary.
T
Tammy MartinNov 18, 2025
What to do if Fromm P328 doesn’t tension?
- J
  Jason CochranNov 18, 2025
  If your Fromm Packaging equipment isn't tensioning, it could be due to the following reasons: * The tensioning wheel might be dirty or worn. Try cleaning it, or replace it if necessary. Avoid using hard objects. * P32.8128 might not be meshing with P32.8130 because spring N2.5296 is defective or parts are dirty. Replace the spring and clean the parts. * The tensioning wheel could be faulty or assembled incorrectly. Ensure it's assembled correctly. * The grippers might be dirty, worn, or wrongly assembled. Replace or clean the grippers, or assemble them correctly, avoiding hard objects. * The gearing parts from the tensioning gear could be defective. Check the tensioning gear and replace any defective parts. * A defective circuit board might be the cause. Replace the circuit bo...

Summary

1.1 ACCESSORIES

1.1.1 Battery

1.1.2 Battery chargers

1.2 TECHNICAL DETAILS

1.2.1 Strap tension

Factors affecting strap tension, including package hardness and strap properties.

1.4 PERIODIC MAINTENANCE AND CONTROL

1.4.1 Procedure

Steps for checking tool condition and performing test strappings.

1.4.2 Troubleshooting

Table of symptoms, causes, and remedies for common tool issues.

1.4.3 Battery test

Procedure for checking battery health during maintenance.

1.4.4 Checklist

1.4.5 Lubrication rules

Guidelines for lubricating gear parts and other components.

1.4.6 Glueing rules

1.4.7 Assembly information

Details on correct assembly of specific parts like bearings and grippers.

Sockets for the motor on the circuit board

1.5 RECOMMENDED SPARE PARTS

1.6 MAINTENANCE PLAN P328

1.8 USE OF ACCESSORY TOOLS

1.9 ORDERING SPARE PARTS

1.9.3 Finding out of the tool type (item number), the serial number and the version number

1.11 CHART OF TYPES

Fromm P328 Specifications

General

Model	P328
Category	Packaging equipment
Manufacturer	Fromm
Sealing Type	Friction weld sealing
Strap Type	PET (Polyester) / PP (Polypropylene)
Strap Thickness	0.40 - 1.05 mm