1-10
Too l do e sn ’t w el d We ld in g gr ip per P 32 .1 5 11 i s di rt y o r
worn
Replace or clean welding gripper,
don’t use any hard objects for this
(see operation manual P328)
Welding stop gripper P32.8107 is dirty
or worn
Replace or clean welding stop gripper,
don’t use any hard objects for this
(see operation manual P328)
Damaged housing parts Replace housing parts
Defective circuit board Replace circuit board
Pressure spring N21.5138 defective Replace pressure spring
Needle free wheeling N3.4509 in
P32.8139 defective or assembled
reversed
Assemble the needle free wheeling
correct or replace it
Gearing parts of the welding gear are
defective
Check welding gear and replace
defective parts
Gear motor N51.1127 defective Replace Gear motor
Too the d belt N4 .3236 o r To oth ed belt
pulley P32.8122 is worn
Replace Toothed belt or
Too t he d be lt pu ll e y
Defective gear bearing Replace bearing
Tool badly cuts the strap or
doesn’t cut at all
Cutter is worn or damaged Replace cutter
(see operation manual P328)
Wrong adjustment of the coupler
P35.0146
Check adjustment and readjust if
necessary
(see operation manual P328)
Welding gripper P32.1511 is worn Replace welding gripper
(see operation manual P328)
Welding time too short Change adjustment
(see operation manual P328)
Defective pressure spring N2.5237 Replace pressure spring
Tool switches off after a few
strappings
(Displaying empty battery)
Battery defective or empty Check the battery and change
defective batteries
Gear noise Tensioning or welding gear is worn Check component parts and replace
defective ones
SYMPTOM CAUSE REMEDY
To Next Page
Loading...
