10
P330mane.fm
5 OPERATING ELEMENTS
6OPERATION
6.1 Installation
Do not expose power tools to rain or wet conditions!
For safety reasons the battery is delivered uncharged.
Charge the battery before working.
See separate operating instruction of the battery charger.
When charging the battery the very first time, we recommend a charging time of at least 12 hours.
Never charge a damaged battery. Replace by a new one immediately.
Do not open batteries and store them only in dry and frost-proof rooms.
The maximum ambient temperature is 50°C.
Keep dry at all times.
Inserting the battery
Insert the battery from top to bottom into the tool
until both unlatching push buttons are engaged.
When inserting the battery the LED - indication
shortly lights green.
Removing the empty battery
If the red LED starts blinking while a tensioning or welding procedure, the capacity of the battery is exhausted.
All electric functions of the tool are locked.
The seal efficiency is insufficient.
Warning! Straps with insufficient seal strength must be removed from the package!
The battery must be recharged.
Push the unlatching push buttons at both sides of the battery.
Push the battery out of the tool in the opposite direction of insertion.
LED - Indication
Green During tensioning the LED
lights green.
Green During welding the LED lights
green.
Yellow Cooling time is running, the
tool must not be removed from
the strap.
Green Cooling time is finished, the
tool can be removed from the
strap.
Red blinking Charge the battery.
Tension button
Sealing lever
Unlatching push button
LED
Handle lever
www.traditionaltool.com
For Parts & Service 1-877-862-6699
To Next Page
Loading...
