11
P330mane.fm
6.2 Displaying of the status of the battery
charge
By pressing a button the status of the battery can be
shown in four steps.
If four lamps are lighting the battery is full.
If only one lamp is lighting shortly the battery has to be
charged.
6.3 Adjustments
6.3.1 Preselecting of strap tension and tensioning speed
Do not adjust the tensioning force too high.
If the tensioning force is higher than the tensioning strength of the strap,
the strap will tear while the tensioning.
Tensioning force and tensioning speed can be preselected
with the upper adjusting knob.
Turning clockwise increases;
turning counter clockwise decreases the tensioning force
and the tensioning speed at the same time.
The tensioning force on the minimum setting is 1200 N
(270 lbs) and it is increased on the maximum setting to
6000 N (1350 lbs).
The tensioning speed on the minimum setting is 70 mm/s
(2,76 inch/sec), it is increasing linear up to 87 mm/s
(3,43 inch/sec) on the maximum setting.
6.3.2 Adjusting the welding time
Depending on the size and quality of the strap, different
welding times are required.
The welding time can be adjusted at the lower adjusting
knob.
Turning clockwise increases,
turning counter clockwise decreases the welding time.
Adjusting knob
welding time
Adjusting knob tensioning force /
tensioning speed
www.traditionaltool.com
For Parts & Service 1-877-862-6699
To Next Page
Loading...
