Fromm P331 M - Page 5

1-10
1.4.3 Battery test
The battery should be checked while each maintenance with a battery tester.
Information to the Battery tester you will get by FROMM System GmbH.
(see 1.10 SERVICE ADDRESS)
• Li-Ion-Batteries 36V / (2,5Ah) must be replaced at a capacity less than approx. 73% (1,83 Ah).
• Li-Ion-Batteries 36V / (4,0Ah) must be replaced at a capacity less than approx. 60% (2,4 Ah)
1.4.4 Checklist
Carry out some test strappings and check following tool components.
• Inserting of the strap
• Insert battery in the tool and check function of the LED-display (see operation manual P331)
• Strap feed and strap tension
• Tension force adjustment (see operation manual P331)
• Cutting of the upper strap
• Welding time adjustment (see operation manual P331)
• Seal quality (see operation manual P331)
• Function of the LED-display (see operation manual P331)
• Correct type label
1.4.5 Lubrication rules
All gear parts have to be lubricated with MOLYKOTE BR2 PLUS grease.
Lubrication interval: While each maintenance or after 12 months at the latest.
All bearing parts of the welding unit have to be cleaned and lubricated as follows:
All other parts have to be lubricated according to the explosion drawing.
Lubrication interval: While each maintenance or after 12 months at the latest.
P32.1029

N3.1702 (6X)

P32.1027


P35.4107

P35.4210

Mobilux EP2
 Klüber Isoflex Alltime SL2
 Klüber Isoflex NBU 15
P35.4111

P35.4111

grease here
P35.4106
