31
EN
Battery protection functions
General The battery protection functions serve to:
- increase the service life of the battery
- protect the battery from long-term damage
- increase the reliability of the power source
Deep discharge
protector
The power source has a deep discharge protector to warn the user if the state of charge of
the battery is too low. If this is the case, the power source switches off.
Function of the deep discharge protector:
- when the battery capacity is exhausted
- all segments of the battery capacity indicator flash
- "Lo" is shown on the display
- welding is no longer possible
- the power source switches off automatically after three minutes
Automatic
switch-off
Automatic switch-off avoids unnecessary power consumption, thereby extending the effec-
tive period of operation with one battery charge.
If the power source is not operated for a specific length of time, it switches off automatically.
To reactivate the power source, press the On/Off button for at least two seconds.
CAUTION! Storing the battery for longer periods in a discharged state may dam-
age the battery.
If the deep discharge protector is triggered, charge the power source immediate-
ly.
NOTE! The factory setting for the automatic switch-off time is 15 minutes (if no
welding is performed for 15 minutes, the power source switches off automatical-
ly). This value can be changed in the Setup menu using the tSd parameter.
To Next Page
Loading...
