23
EN
Warning notices
on the device
The cooling unit is fitted with safety symbols and a rating plate. The rating plate and safety
symbols must not be removed or painted over. The symbols warn against operating the
equipment incorrectly, as this may result in serious injury and damage.
Welding is dangerous. The following
basic requirements must be met to en-
sure the equipment is used properly:
- Welders must be sufficiently quali-
fied
- Suitable protective equipment
must be used
- All persons not involved must be
kept at a safe distance from the
cooling unit and the welding pro-
cess
Do not use the functions described here
until you have thoroughly read and un-
derstood the following documents:
- this document
- all documents relating to the sys-
tem components, especially the
safety rules
Do not dispose of used devices with do-
mestic waste. Dispose of them accord-
ing to the safety rules.
0.42 MPa (4.2 bar) 1.0 kWP
1l/min
1~
50 Hz
IEC 60 974-2/-10 Cl.A IP 23
0.7 A
U
1
400 V
p
max
I
1
www.fronius.com
Ser.No.:
Part No.:
p
max
I
1
To Next Page
Loading...
