37
EN
Filling and starting up the cooling unit
Filling the cooling
unit
WARNING!
Danger from electric current.
An electric shock can be fatal.
► Turn the power source mains switch to the "O" position.
► Disconnect the power source from the mains.
► Ensure that the power source remains disconnected from the mains until all work has
been completed.
CAUTION!
Risk from coolant leakage
This can result in serious damage to property.
► If there is any coolant on the exterior of the cooling unit, remove it immediately.
► Make sure that no coolant gets into the device.
CAUTION!
Risk due to work that has been carried out incorrectly
This can result in serious damage to property.
► If the coolant connections are on the front of the cooling unit, carry out the following
steps as shown – but at the front coolant flow connection (blue).
1 2
1
To Next Page
Loading...
