EasyManua.ls Logo

Fronius IG 400 - Class 5

Fronius IG 400
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
62
Power module is restarted
after a cooling-down period
441 Failure of a power-mo-
dule fan
If a service code appears
frequently: Notify FRO-
NIUS-trained service
engineer
Code Designation Manifestation Remedy
Class 4
(continued)
Power cannot be fed into
the mains symmetrically
because of a mains fault
The FRONIUS IG is locked
out
The red LED indicates a cri-
tical error
442 No phase master found Disconnect DC side
If a service code appears
frequently: Notify FRO-
NIUS-trained service
engineer
FRONIUS IG address has
been assigned twice
The LocalNet components
required are in the FRONI-
US IG: However, no com-
munication is possible
504 Communication with
LocalNet not possible
Change FRONIUS IG
address (see chapter
entitled „The Setup
Menu“)
The status message
goes off once the FRO-
NIUS IG address has
been changed
Some items of data from the
service menu are lost
505 EEPROM defective Fault rectified automati-
cally
Some items of data from the
„Total“ menu are lost
506 EEPROM defective Fault rectified automati-
cally
Some items of data from the
„Day“/“Year“ menu are lost
507 EEPROM defective Fault rectified automati-
cally
The address for data com-
munication is no longer
stored
508 FRONIUS IG address
contains an error
Redefine address
Excessive temperature in
device despite the fact that
little power is being deliver-
ed
501 Faulty fan
Ventilation slots blo-
cked
Class 5 service codes do not generally interfere with feeding power into the mains. A
service code is displayed until it is acknowledged by pressing a key (however, the
FRONIUS IG continues to operate normally in the background).
- Press any key
- The error message disappears from the display
Code Designation Description
Contact your system en-
gineer
Uncover ventilation slots
Remedy
While automatically measu-
ring the insulation, the FRO-
NIUS IG has detected an
insulation fault to earth
502 Insulation value too low Check the insulation of
your photovoltaic system
Service code appears
again: Contact your sys-
tem engineer
Class 5

Table of Contents

Related product manuals