Safety
Intended use The MIG/MAG manual welding torch is intended solely for MIG/MAG welding in manual
applications.
Any other use is deemed to be "not in accordance with the intended purpose.” The
manufacturer shall not be liable for any damage resulting from such improper use.
Intended use also means:
- Following all the instructions in the Operating Instructions
- Carrying out all the specified inspection and maintenance work
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in severe personal injury and damage to property.
▶
All the work and functions described in this document must only be carried out by
trained and qualified personnel.
▶
Read and understand this document.
▶
Read and understand all the Operating Instructions for the system components,
especially the safety rules.
WARNING!
Danger from electrical current and danger of injury from emerging wire electrode.
This can result in severe personal injury and damage to property.
▶
Switch the power switch on the power source to - O -.
▶
Disconnect the power source from the grid.
▶
Ensure that the power source remains disconnected from the grid until all work is
complete.
WARNING!
Danger from electrical current.
This can result in severe personal injury and damage to property.
▶
All cables, leads, and hosepacks must always be securely connected, undamaged,
correctly insulated, and adequately sized.
CAUTION!
Burning hazard due to hot welding torch components and coolant.
Serious burns may result.
▶
Allow all welding torch components and the coolant to cool down to room tempera-
ture (+25 °C or +77 °F) before starting any of the work described in these Operating
Instructions.
30
To Next Page
Loading...
