Fronius RCU 4000 - Comfort Control Panel Description - Core Controls; Adjusting Dial and Parameter Selection Buttons

33
EN
Description of
“Comfort”
control panel
(continued)
(1) Adjusting dial ... for altering parameters. If the indicator next to the adjusting dial is
lit up, then the selected parameter is one that can be altered.
(2) Parameter selection button ... for selecting the following parameters:
- “a”-dimension
- sheet thickness
- welding current
- wire speed
- indicator F1
- Wirefeed-drive current input
If the indicator is lit up on the parameter selection button and on the adjusting dial,
then the indicated / selected parameter can be altered with the adjusting dial.
(3) Parameter selection button ... for selecting the following parameters:
- arc-length correction
- droplet-detachment / arc-force (dynamic) correction
- welding voltage
- welding speed
- job n°
- indicator F3
If the indicator is lit up on the parameter selection button and on the adjusting dial,
then the indicated / selected parameter can be altered with the adjusting dial.
(1)(24)
(23)
(19)
(18)
(16)
(15)
(14)
(13)
(12)(11)
(9)(8) (3)(2)
(19)
(22)
(21) (20)
(7) (6)
(5)
(4)
(10)
(17)
Fig.2 “Comfort” control panel