Fronius Smart Meter TS 65A-3 - Page 18

Cabling IMPORTANT!
Always switch off the power supply before connecting the mains voltage inputs to the
Fronius Smart Meter TS.
Recommended thickness of stranded mains voltage cables for the terminals of the
measuring input and measuring output:
- Wire: 1 - 16 mm²
- Recommended torque: max. 2.8 Nm
Recommended thickness of stranded wires for data communication terminals:
- Wire: min. 0.05 mm²
- Recommended torque: max. 0.4 Nm
Connect each voltage cable to the terminal strip as shown in the graphics below.
N
L1
L2
L3
3N
L1
L2
L3
3
N
L2
L1
2N
18