Fronius Smart Meter TS Series User Manual

1
Press and hold "Down/Enter" for 2
seconds.
2
Press "Up" or "Down/Enter" to access
the P1 screen.
3
Set password "2633" with "Up" and
"Down/Enter" and confirm each indi-
vidual value with "Down/Enter".
4
Note down the password.
IMPORTANT!
The password cannot be reset.
1
Press "Up" or "Down/Enter" to access
the P10 screen.
2
Press and hold "Down/Enter" for 2
seconds.
3
Set the address with "Up" and "Down/
Enter" and confirm each individual
value with "Down/Enter".
4
Press "Up" to access the P14 screen
and press and hold "Enter" for 2
seconds to exit the settings.
28

Fronius Smart Meter TS Series Specifications

General

Communication Interface	RS485, Modbus RTU, M-Bus, Ethernet (depending on model)
Protection Class	IP20
Voltage Range	3 x 230/400 V (depending on model)
Frequency	50 Hz
Power Consumption	< 2 VA per phase
Mounting	DIN rail
Rated Voltage	3 x 230/400 V (depending on model)