38
Options
Options
4.75 in.
120 mm
4 in.
100 mm
2.75 in.
70 mm
NOTE! A DIN rail is provided in
order to mount accessory electri-
cal devices including, but not limit-
ed to, overcurrent protection,
metering, radio or cellular modem.
Maximum size for mounting of all
devices is 4w x 4,75l x 2,75 inch-
es. The installer takes responsibil-
ity for any undesired effect on the
inverter by installing an electrical
device in this area, caution should
be taken when installing a device
that may output significant
amounts of heat or radio interfer-
ence. Always insure that the de-
vice does not inhibit the inverter
from closing and sealing properly.
Any questions about device eligi-
bility should be directed toward
technical support.
To Next Page
Loading...
