35
EN-US
Display Settings
Daylight saving time
Activating/deactivating the automatic adjustment for daylight saving time
IMPORTANT! Only use the function for automatic daylight savings adjustment when
there are no LAN or WLAN-compatible system components in a Fronius Solar Net Ring
(e.g., Fronius Datalogger Web, Fronius Datamanager or Fronius Hybridmanager).
If there are LAN or WLAN-compatible system components, set this function on the web
interface for the system component.
Setting range on/off
Factory setting on
IMPORTANT! The time and date must be set correctly for day and year values to be dis-
played properly.
Setting range Language / Night mode / Contrast / Illumination
Language
Setting the display language
Setting range German, English, French, Dutch, Italian, Spanish, Czech, Slo-
vak, etc.
Night Mode
DATCOM night mode; controls DATCOM and display operation at night or when there is
insufficient DC voltage available
Setting range AUTO / ON / OFF
Factory setting OFF
AUTO: DATCOM operation is constant as long as a Datalogger is connected to an
active, uninterrupted Solar Net.
The display is dark during the night and can be activated by pressing any
key.
ON: DATCOM operation is constant. The inverter provides 12 V constantly to
supply Solar Net with power. The display is always active.
IMPORTANT! The power consumption of the inverter is increased at night
to approximately 7 W when the DATCOM night mode is ON or on AUTO and
Solar Net components are connected.
OFF: No DATCOM operation at night, the inverter requires no AC power to supply
Solar Net.
The display is deactivated at night; the Fronius Datamanager is not avail-
able.
Contrast
set contrast on the display
Setting range 0–10
Factory setting 5
To Next Page
Loading...
