39
EN-US
Version Display of version number and serial number of the PC boards installed in the inverter (e.g.,
for service purposes)
General: Device type
Fam.
Country-specific setting Setup – set country setup
Version – country setup version
Group – inverter software update group
MPP Tracker: Tracker 1
Tracker 2 (for Fronius Symo only, except Fronius Symo 15.0-3
208)
Grid monitoring: GMTi – startup time of the inverter in s
GMTr – restart time in s after a grid error
ULL – grid voltage average value over 10 minutes in V.
LLTrip – detection time for long-term voltage monitoring
Grid voltage limits: UILmax – upper inner grid voltage value in V
UILmin – lower inner grid voltage value in V
Grid frequency limits: FILmax – upper inner grid frequency value in Hz
FILmin – lower inner grid frequency value in Hz
Q-Mode: Currently set power factor (cos phi)
(e.g., constant cos(phi)/constant Q/Q(U) characteristic/etc.)
AC power limit: Max. P AC – manual power reduction
AC voltage derating: Status – ON/OFF voltage-dependent power reduction
GVDPRe – threshold from which the voltage-dependent power
reduction starts
GVDPRv – reduction gradient used to reduce the power, e.g.,
10% per volt higher than the GVDPRe threshold.
Message – activates the sending of an info message via Solar
Net
Fault Ride Through: Status – default setting: OFF
If the function is activated, the inverter does not switch off im-
mediately when a short-term interruption to the AC voltage oc-
curs (outside of the limits set by the grid supplier); instead it
continues to supply power for a defined time.
DB min – default setting: 90%
"Dead Band Minimum" setting (%)
DB max – default setting: 120%
"Dead Band Maximum" setting (%)
k-Fac. default setting: 0
To Next Page
Loading...
