Fronius TransSteel 5000 Rob - MIG;MAG Welding Modes

50
MIG/MAG modes
General remarks
For details of the meaning, settings, setting range and units of the available parameters
(e.g. GPr), please refer to the section entitled "Setup parameters".
The illustrated welding torch symbols represent setting, maintaining and cancelling the ro-
bot signal for the start of welding.
Symbols
2-step mode "2-step mode" is suitable for
- Tacking work
- Short weld seams
4-step mode
"4-step mode" is suitable for longer weld
seams.
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
press hold release
I
GPr
GPo
t
I
+
I
GPr
GPo
t
I
+
+