Fronius TransSteel 5000 Rob - Setup Menu Level 2 and Circuit Measurements

71
EN
Setup menu - Level 2
Level 2 setup
menu
Accessing the setup menu
The control panel is now in the setup menu - the last setup parameter that was selected is
displayed.
Selecting the "2nd" parameter
Accessing the Level 2 setup menu
Changing parameters
Exiting the Level 2 setup menu
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
Use the "Mode" and "Process" buttons or the left-hand adjusting
dial to select the "2nd" setup parameter
1
2
3
4
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
Use the "Mode" and "Process" buttons or the left-hand adjusting
dial to select the required setup parameter
5
6
7
8
Change the value of the setup parameter using the "Parameter
selection" buttons or the right-hand adjusting dial
9
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
10
11
12