141
EN
When the power source is reset, jobs are not deleted but are retained in the memory. The
functions in the second level of the Setup menu (2nd) are also not deleted. Exception: Ig-
nition time-out welding parameter (ito).
Parameters for
TIG welding in the
Process setup
menu
Parameters for
MMA welding in
the Process setup
menu
NOTE! When the power source is reset, all the customised settings in the Setup
menu are lost.
2nd
Second level of the Setup menu (see “Setup menu - level 2”)
2nd
Second level of the Setup menu (see “Setup menu - level 2”)
NOTE! If you reset the power source using the Factory parameter FAC, the hot-
current time (Hti) and hot-start current (HCU) parameters are also reset.
Hti
Hot-current time
Unit s
Setting range 0 - 2.0
Factory setting 0.5
HCU
Hot-start current
Unit %
Setting range 0 - 200
Factory setting 150
2nd
Second level of the Setup menu (see “Setup menu - level 2”)
To Next Page
Loading...
