Fronius TransSynergic 5000 - Preparing the Wire-Feed Unit

91
EN
Establish a ground (earth) connection between the workpiece and power source
Connect the gas cylinder
Connect the RCU 5000i remote control
Make the connection to the robot control
Preparing the
wire-feed unit
Carry out the following steps in accordance with the wire-feed unit operating instructions:
Insert the feed rollers in the wire-feed unit
Insert the wirespool or basket-type spool with adapter in the wire-feed unit
Feed in the wire electrode
Set the contact pressure
Adjust the brake
2
3
4
5
1
2
3
4
5