Frontpoint WIRELESS DOORBELL CAMERA - Viewing Live & Saved Video; Two-Way Audio

PART II: USAGE
After completing the setup on your Wireless Doorbell Camera, you’re ready to start
using your new Wireless Doorbell Camera! The below steps outline key functionalities.
VIEW LIVE AND SAVED VIDEO
To view live and saved video from your Wireless Doorbell Camera in the Frontpoint
app, follow the steps below:
1. Tap “Doorbell Camera” in the navigation menu ( ).
2. In the “Live” menu option found along the top of the page, tap “Start Video” in
the video window to view live streaming video.
A. To arm/disarm your system directly from the Live screen, tap “Actions” at the bot-
tom of the video live feed.
i. If you have automation devices (like an Outdoor Smart Plug, Wireless
Light Control, or Smart Lock), additional options to control them will be
presented, allowing you to unlock the door or turn the light on for your
guests.
3. In the “Saved” menu option found along the top of the page, tap a video clip to
review your recording.
A. Refer to the options at the top to name, share, sand send your recorded clips.
USE TWO-WAY AUDIO
To talk with guests outside your door from the Frontpoint app, follow the steps below:
• Open your Doorbell Camera’s live video window in full screen by tapping “Start
Video” in the middle of the window.
B. To speak through the camera, press and hold the microphone button. Release the
button to listen.
C. Mute or unmute incoming audio by toggling the speaker button in the top left
corner.
1
2
A
i
3
A
A
B
18
CHARGING THE BATTERY
The battery can last up to 6 months before recharging but varies based on activity
level, temperature, and image quality.
To check the battery level of your Wireless Doorbell Camera:
1. Log into the Frontpoint app.
2. Tap “Doorbell Camera” in the navigation menu ( ).
3. Tap in the top right corner.
4. Refer to “Battery Level” to see the current percentage.
To charge the Wireless Doorbell Camera’s battery, follow the steps below:
1. Remove the battery from the camera body:
A. Unlatch the bottom of the Standard Mounting Bracket.
B. Remove the Wireless Doorbell from the Standard Mounting Bracket.
C. Separate the battery pack from the Wireless Doorbell’s body by pulling down on
the bottom of the Wireless Doorbell Camera.
2. Plug the included micro-USB cable into the battery.
3. Plug the USB end of the cable into a USB wall charger* and insert the charger
into an outlet.
*We recommend using a 5V/1.5A USB wall charger for the most eicient charging.