Frymaster Performance MJ40 - Page 22

2-12
DANGER
Conversion of this appliance from one type of gas to another should only be performed
by qualified, licensed, and authorized installation or service personnel, as defined in
Section 1.7 of this manual.
CE Gas Conversion Instructions
1. Between G20- and G25-type Natural Gas, adjust the gas pressure at the regulator. (Refer to the
CE Standard Burner Manifold Gas Pressure Chart.) Do not change the orifice or pilot.
2. Between a 2
nd
family gas (G20 or G25) and a 3
rd
family gas (G31 Propane):
a. Change the orifices.
b. Change the pilot.
c. Change the gas valve regulator or the gas valve.
d. Adjust the manifold pressure.
3. Affix the new label included with the conversion kit next to the existing rating plate stating that
the gas type has been converted. Remove any references to the previously used gas from the
existing rating plate.
4. If the destination language changes, replace the labels. Call your local service agency or kitchen
equipment supplier for a label kit. The language of reference will be on the corner of the label.
The following CE gas-conversion components and kits are available from your FAS:
Honeywell G31 (propane) gas valves can be adjusted for G20 and G25 (natural) gases, but G20
and G25 gas valves cannot be adjusted for G31. Therefore, if converting from a G20 or G25 gas
to G31 gas, in addition to the pilot and orifices, the gas valve must be changed. The table below
identifies the parts required to convert from one gas family to another:
2
nd
Family (G20/G25) to 3
rd
Family (G31) 3
rd
Family (G31) to 2
nd
Family (G20/G25)
810-0427 pilot orifices (2 Required)* 810-0426 pilot orifices (2 Required)*
807-2121 CE Gas Valve (Millivolt) Adjust Gas Valve (No Replacement Required)*
*Quantity required is one unless otherwise noted. Conversion rating label PN 802-2144
Propane (G31) to Natural (G20/G25)
Regulator only: P/N 810-1292
Pilot, regulator, and orifices kits:
P/N 826-1201 (Model 50
Natural (G20/G25) to Propane (G31)
Regulator only: P/N 810-1292
Pilot, regulator, and orifices kits:
P/N 826-1202
(
Model 50
)