Command: AOIWN
Description:
Allows sizing adjustments of the input source with respect to the output raster.
Parameters:
n – Right Edge
n – Horizontal Width (Pixels)
n – Bottom Edge
n – Vertical Height (Lines)
sclr – Scaler [A|B|M|P]; Scaler A | Scaler B | Main | Preview
Example:
AOIWN A? : Returns for Scaler A: =n n n n n, (=Right Edge, Horizontal Width, Bottom Edge, Vertical Height, Clock
Samples per Line).
Command: AVS t m
Description: Sets integration or presentation mode
Set audio video mode t[0,1] 0:integration 1:presentation
m[1…3] 1: Video 2: Audio 3: Both
Command: CHKSUM
Description:
Returns the list of flash-stored file checksums
Parameters:
None
Example:
CHKSUM: Returns the following.
Flash-stored file checksums.
ab25 - spinc.rbf
4a6f - spoc.rbf
d4ec - spmx.rbf
2b69 - terminal.bin
57c6 - pm_menu.cs
d3ff - Compass S2.dwn
Command: CMDST?
Description:
Returns status of the last command that executed
Parameters:
None
Example:
CMDST? : 0 = Completed; 1 = Format Error; 2 = Range Error;
3 = Execution Error; 4 = Command Not Available Error.
Command: COMCK op
Description:
Allows a remote control system to verify communications between itself and the Compass S2.
Parameters:
op – [D]ownload or [U]pload data
n – Amount of data to upload or download. This is an optional parameter that defaults to 128 bytes.
Example:
COMCK U : After the terminating <CR>, the systems waits for 128 bytes to be sent.
40 Compass S
2
To Next Page
Loading...