COMCK D : The system transmits 128 bytes to the remote controller.
Command: DEBUG?
Description:
Returns the status of Debug Mode.
Parameters:
None
Example:
DEBUG? : 0 = Debug Mode Disabled; 1 = Debug Mode Enabled
Command: DL op n sdr
Description:
Download input file configurations or a Program Sequence from the Compass S2.
Parameters:
op - Input configuration or Program Sequence; [I|P]
nn - Index Number; [0-64]
sclr - Scaler [A|B|M|P]; Scaler A | Scaler B | Main | Preview
Example:
DL I 2 : Download input configuration at index 2.
DL I 0 A : Download the current information loaded on Scaler A.
DL P 1 : Download the stored program sequence steps.
Command: ECHO prt n
Description:
Enable or Disable ECHO.
Parameters:
port - Com Port; [A|B] Note: Com A = 25-pin Remote Port
n - Disable or Enable; [0|1]
Example:
ECHO A 0 : Disable ECHO on Com A.
Command: FREEZ n sclr
Description:
Enable/Disable Freeze.
Parameters:
n - Freeze Enable/Disable; n[0|1], OFF|ON
sclr - Scaler [A|B|M|P]; Scaler A | Scaler B | Main | Preview
Example:
FREEZ 1 A: Enables freeze on the display on Scaler A
FREEZ 0: Disables freeze on the display on Scaler A.
Command: FSB n sclr
Description:
Force Scaler Black.
Parameters:
n - Force Scaler Black Disable/Enable; n[0|1], OFF|ON
sclr - Scaler [A|B|M|P]; Scaler A | Scaler B | Main | Preview
Example:
FSB 1 A: Scaler A will show a black screen
FSB 0 A: Scaler A will show the current input source.
Compass S
2
41
To Next Page
Loading...