Fuji Electric ZKJ Series - Page 23

3 - 10
Dedicated cable
(1 meter long)
Analyzer main unit
Input/output
terminal module
Ferrite core
Ferrite core
3.5.2 Input/output terminal module
This analyzer should be connected to the input/output terminal module by supplied dedicated
cable.
Plug this cable connector into the receptacle at the rear panel of the analyzer and the receptacle on
WKH3&%RIWKHLQSXWRXWSXWPRGXOH
(1) Analog output signal (AO):
terminal block 1 (1) to (20), terminal block 2 (3) to (6)
2XWSXWVLJQDO WRP$'&RUWR9'&VHOHFWHGZKHQRUGHULQJ
Non-insulated output
$OORZDEOHORDGWRP$'&RUOHVV
  WR9'&NRUPRUH
 $QDORJRXWSXWLVSURYLGHGIURPHDFKWHUPLQDOFRUUHVSRQGLQJWRWKHFKDQQHOGLVSOD\HGLQWKH
measurement screen.
All of analog output signals for the instrument are not isolated. It is recommended
to isolate signals individually to prevent interference from unnecessary signals or to
SUHYHQWH[WHUQDOLQWHUIHUHQFHHVSHFLDOO\OHDGLQJWKHFDEOHRIPRUHWKDQPHWHUVRU
to outdoor.
CAUTION