Fuji Electric ZKJ Series - Setting of Auto Zero Calibration; Auto Zero Calibration

6 - 20
6.5 Setting of auto zero calibration
6.5.1 Auto zero calibration
Auto zero calibration is automatically carried
out at the time when zero calibration is set.
&RPSRQHQWVIRUZKLFKDFDOLEUDWLRQLVWREH
made are determined by setting of auto cali-
bration component in Section 6.2.4.
Before changing the setting of auto zero cali-
bration, set the ON/OFF to OFF.
( )
ENT
MODE
( )
ENT
( )
ENT
Description of setting items
6WDUW7LPH 6HWWLQJDWWKHILUVWFDOLEUDWLRQ
  GD\RIWKHZHHNKRXUPLQXWH
&\FOH  $SHULRGEHWZHHQWKHVWDUWWLPHRIRQH
  FDOLEUDWLRQDQGDQRWKHU
  XQLWKRXUGD\
)ORZ7LPH 7KHWLPHUHTXLUHGIRUWKHFDOLEUDWLRQJDV
  WREHUHSODFHGLQWKHFHOO
212))  212))RIDXWR]HURFDOLEUDWLRQ
To close the “Setting of Auto Zero Calibration”
or cancel this mode midway, press the key.
A previous screen will return.
To close "setting of Auto Zero Calibration"
ESC
 'XULQJPHDVXUHPHQWSUHVVWKH
MODE
key to
GLVSOD\WKH8VHUPRGH
 3RLQWWKHFXUVRUWR³6HWWLQJRI$XWR=HUR
&DOLEUDWLRQ´E\SUHVVLQJWKH
or
key. Press the
ENT
key.
 ,QWKH³6HWWLQJRI$XWR=HUR&DOLEUDWLRQ´
screen that appears, point the cursor to
any item you want to set by pressing the
or key. Press the
ENT
key.
 ,QWKH³$XWR=HUR&DOLEUDWLRQ3DUDPHWHU
6HWWLQJ´VFUHHQWKDWDSSHDUVSHUIRUPWKH
value entry or the setting. For the value
entry or setting change, use the
or
key. To change the setting, use the
key to move the cursor to the right.
After setting, press the
ENT
key, and auto
zero calibration is carried out by the en-
tered setting value.
End of Auto Zero Calibration Setting
Press the or
the key, and
date and time are
displayed
alternately.
Measurement Mode
0 0
User Mode Select an item
with
UP/DOWN and ENT
Back with ESC
Switch Ranges
Calibration Para meters
0
Alarm Setting
Setting
of Auto Calibration
~ Setting of Auto Zero Calibration
Setting of Peak Alarm
Para meter Setting 0 0
0 ~i 000
0
0
0 0
0
0
Set Auto
Select setting item
Zero Cal.
~ Start Ti me SUI\J 12:00
Cycle
07
day
Flow Time 300 sec
ON/ OFF OFF
Time : rv1ON 12:34
Auto Zero Calibration Run
Set Auto Set Start Ti me
Zero Cal.
~ Start Ti me 1111112:00
0
Cycle
07
day --
0
Flow Time 300 sec
ON/ OFF OFF
Time : rv1ON 1234
Auto Zero Calibration Run
~} 0
0U