Need help?Do you have a question about the Fuji Electric ZRE-2 and is the answer not in the manual?
General| Brand | Fuji Electric |
|---|---|
| Model | ZRE-2 |
| Category | Measuring Instruments |
| Language | English |
Defines safety classification levels used throughout the manual.
Important safety precautions for handling and installing the analyzer.
Safety guidelines for connecting gas tubes to prevent leaks and hazards.
Electrical safety measures during wiring to prevent shock and fire.
General safety advice for operating the analyzer correctly and safely.
Safety procedures for maintenance and checks to avoid electrical shock and injury.
Advice on contacting technicians if faults cannot be identified.
Explains the NDIR measurement principle and typical application areas.
Lists all components included in the product package for user verification.
Identifies and explains the functions of the analyzer's front and rear panel components.
Specifies the environmental and electrical conditions required for optimal installation.
Details methods for mounting the analyzer main frame in racks or panels.
Instructions for connecting gas inlet, outlet, and purge lines to the analyzer.
Defines the necessary conditions and preparation for sampling gas used by the analyzer.
Guidelines for safe and correct electrical wiring and connector setup.
Steps to check tubes, wiring, and prepare the analyzer before starting operation.
Procedures for warm-up, settings, calibration, and introducing measuring gas.
Identifies each key on the operation panel and describes its function.
Provides an overview of the display screens and the navigation flow through the operation panels.
Explains the layout and components of the measurement mode screen.
Describes how to navigate between measurement mode and user mode for settings.
How to set and switch measurement ranges manually or automatically.
Procedure to set the concentration values for zero and span calibration gases.
Step-by-step guide for performing manual zero and span calibration for components.
Configuration for automatic calibration, including components, ranges, and timing.
How to configure alarm limits, hysteresis, and enable/disable alarms.
Settings for system parameters like time, key lock, and backlight.
Procedure to access maintenance functions using passwords and navigate menus.
Managing calibration history and adjusting analog output signals.
Daily and weekly procedures for checking indication values and gas flow rates.
Instructions for disassembling, cleaning, and reassembling the sampling cell.
How to clean the analyzer's exterior enclosure safely.
Specific calibration methods for heat treatment furnace applications using standard or check gas.
Lists error numbers, their contents, and probable causes for quick reference.
Guidance on resolving common errors, including screen displays and recovery steps.
How to view and clear the error history log file stored in maintenance mode.
Details the analyzer's measurement principle, measurable components, and ranges.
Explains standard operational functions like signal holding, range switching, and auto calibration.
Lists performance metrics including repeatability, linearity, drift, and response time.
Information on the analyzer's compliance with Low Voltage and EMC directives.
Explains how to interpret the model code symbols for configuration options.
Shows the physical dimensions and views of the analyzer main unit.
To Next Page
