Fuji Electric ZRE-2 - Display and Operation Panels; Operation Panel Layout

19
INZ-TN2ZRE-E
 
This section describes the display unit and operation panel of the analyzer unit. It also explains the name
and description of function on the operation panel.

Operation panel
Display unit
⑦ ZERO key
⑧ SPAN key
⑥ ENT key
② SIDE key
⑤ ESC key
① MODE key
③ UP key
④ DOWN key
MODE ZERO SPAN
ENTER
ESC
• Display unit: The measurement screen and the setting items are displayed.
• Operation panel: The configuration is as shown below.
ESC
SPANMODE
ENTER
ZERO
POWER
GAS ZRE ANALYZER
Used to switch the mode. Used to return to the previous screen or
cancel the setting midway.
① MODE key ⑤ ESC key
Used to change the selected item (by
moving the cursor) and to decrease the
numeral value.
Used for span calibration.④ DOWN key ⑧ SPAN key
Used to change the selected item (by
moving the cursor) and to increase the
numeral value.
Used for zero calibration.③ UP key ⑦ ZERO key
Used to change the selected item (by
moving the cursor) and the numeral digit.
Used for confirmation of selected items
or values, and for execution of calibra-
tion.
② SIDE key ⑥ ENT key
Description DescriptionName Name
Fig. 5-1