Fuji Electric ZRE-2 - Parameter Setting

46
INZ-TN2ZRE-E
• Current Time : Current year, month, date, day of the week, hour, and minute setting
(The display appears in this order.)
Note) The clock backup time is 2 days. If power is turned on after it is kept off
for 2 days or longer, make the time setting again.
• Key Lock : Invalidates any key operation except canceling the key lock.
• Output Hold : Sets whether Calibration Output is held or not, and the holding value setting.
• Response time : Sets the response time of electrical system.
• Average Period : Sets the moving average time.
• Backlight Timer : Sets automatic OFF of the backlight of display unit and the time until backlight out.
• Contrast : Adjusts contrast of the LCD.
• Maintenance mode : Enters passwords to switch to the Maintenance mode.
Description of setting items
 
It allows you to carry out the parameter setting such as time, key lock, etc., as required.
Items to be set are as follows:
* For the maintenance mode, see Item 6.7.
(1) Enter the “Parameter setting” screen from
the user mode, and the display shown
at right appears. Operate the
or the
key until the cursor is aligned with a
desired item and press the
ENT
key.
( )
ENT
(2) In the “Parameter Setting” screen that
appears, perform the value entry or the
setting. For the value entry or setting
change , use the
or the key, and
the
key move the cursor to the right.
To close the “Parameter Setting” screen
or cancel this mode midway, press the
key. A previous screen will return.
To close Parameter Setting screen
ESC
ENT
