iv
INZ-TN2ZRE-E
Caution on use
• Do not touch the input/output terminals with metal or nger.
Otherwise, electric shock or injury may result.
• Do not smoke or use ames near the analyzer. Otherwise, re
may result.
• Do not allow water to enter the analyzer. Otherwise, electric
shock or internal re may result.
Caution on maintenance and check
• Before performing work with the cover of the analyzer kept
open for maintenance and check, be sure to purge completely
not only within the analyzer but also measuring gas lines with
nitrogen or air. Otherwise, poisoning, re, or explosion may
result due to gas leakage.
Be sure to observe the following to perform work safely,
avoiding electric shock or injury.
• Remove the watch and other metallic objects before work.
• Do not touch the instrument with wet hands.
• If the fuse is blown, eliminate the cause and replace it with the
one of the same capacity and type. Otherwise, electric shock or
accidents may result.
• Do not use replacement parts other than those specied by the
manufacturer. Otherwise, intended performance may not be
achieved. Besides accidents or failures may result.
• Dispose replacement parts such as maintenance parts as incom-
bustibles according to the local waste disposal regulations.
Others
• If the cause of any fault cannot be identied by referring to the
instruction manual, be sure to contact your dealer or Fuji’s tech-
nician in charge of adjustment. Disassembling the instrument
carelessly may result in electric shock or injury.
To Next Page
Loading...
