Fuji Electric ZKJ Series - Page 68

6 - 28
(4) In the Parameter Setting screen that ap-
pears, enter the numeric values and set
WKHLWHPV(QWHULQJWKHQXPHULFYDOXHV
or setting the items should be carried out
by using the
or key. To move
the cursor to the right, press the
key.
After setting, press the
ENT
key, that the
parameter setting is carried out with the
value you set.
Output Hold
By setting an output hold to ON, an output signal of each channel are held during the calibration
PDQXDOFDOLEUDWLRQDQGDXWRFDOLEUDWLRQDQGIRUWKHJDVÀRZWLPHUHIHUWR6HFWLRQ6HWWLQJRI
$XWR&DOLEUDWLRQ5HJDUGOHVVRI+ROG212))VHWWLQJDQRXWSXWVLJQDOFDQEHKHOGYLDDQH[WHU-
nal input.
(1) With manual calibration
To close the “Parameter Setting” screen
or cancel this mode midway, press the
key.
A previous screen will return.
To close Parameter Setting screen
ESC
ENT
Parameter
Current Time 05/01/27 THU 13:50
Key Lock OFF
Output Hold OFF Current
Reset Av. Output Reset
Response Time
Average Period
Backlight Timer ON 5min
Contrast
To Maintenance Mode 0000
Set day of week
+ROGVHWWLQJ WR)6
5HVSRQVHWLPH WRVHF ,QLWLDOYDOXHVHF
$YHUDJHSHULRG WRPLQRUWRKRXUV ,QLWLDOYDOXHKRXU
 :KHQVHWWLQJWKHXQLWRIWRPLQXWHVLVWHUPVRIPLQXWH
 RUWRKRXUVZLWKKRXU
%DFNOLJKW7LPHU WRPLQ,QLWLDOYDOXH2))
0DLQWHQDQFHPRGHWR ,QLWLDOYDOXH
Setting Range
Calibration
Output hold
Press the key to flow gas.
To execute calibration, press the ENT key.
Hold extending
time.
Time set to gas flow time (See Section 6.4 Auto Calibration.)
or
ENT
ENT
ZERO
SPAN
End of Parameter Setting
0
I
0 0
0 0
0
0 0
0
,---
'
'
'
'
'
'
'
' --------'
-
I
l
I
-