14 Problem Solving
494
Problem Solving
14
033-700
[Cause] The connection is time out when a fax is send or the machine receives a fax from a
remote machine.
[Remedy] In sending a fax, execute the operation again. In receiving a fax, the remote machine
may cancel sending. Check the situation of the remote machine.
033-710
[Cause] The document to be sent by polling was deleted.
[Remedy] Store the document again.
033-712
[Cause] Unable to process because of insufficient memory.
[Remedy] Delete unnecessary data.
033-713
[Cause] An error occurred during fax transmission.
[Remedy] Contact our Customer Support Center.
033-716
[Cause] The folder specified from the sender's machine does not exist.
[Remedy] Register the folder.
Refer to "Create Folder" (P.236).
033-717
[Cause] The folder passcode specified from the sender's machine is incorrect. Or, the machine
passcode for reception is incorrect.
[Remedy] Inform the correct information to the sender's machine.
033-718
[Cause] Fax or polling documents do not exist in the folder specified from the sender's machine.
[Remedy] Store fax or polling documents into the folder as necessary.
033-719
[Cause] The document may be deleted by turning the machine off and then on.
[Remedy] Retry sending.
033-721
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
033-724
[Cause] The reception was interrupted because the image volume exceeded the upper limit.
[Remedy] Install the Extension System Memory to increase the maximum volume of image data.
033-725
[Cause] The hard disk is full.
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
033-726
[Cause] The received document was printed with 1 sided printing, because 2 sided printing is not
available for mixed sized documents.
[Remedy] No measure is required.
033-728
[Cause] The auto print formatting of the received fax document was interrupted by a manual
print operation.
[Remedy] No measure is required. The machine will automatically start the auto print job after
manual printing completes.
033-731
[Cause] The printing of the received fax document was interrupted.
[Remedy] The auto print processing of the received fax document was interrupted by a manual
print operation. No measure is required.
033-732
[Cause] An error occurred while connecting to the EP system.
[Remedy] This is an error occurring during maintenance work by Fuji Xerox. No measure is
required.
Error Code Cause and Remedy