Fuji Xerox ApeosPort-V C3320 Administrator's Guide

Error Code
495
Problem Solving
14
033-733
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
033-734
[Cause] Because a report job was instructed while preparing to print a received fax, the printing
of the received fax is temporarily suspended.
[Remedy] No measure is required.
033-735
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
033-736
[Cause] The forwarding job was interrupted because the data volume exceeded the upper limit.
[Remedy] No measure is required.
033-737
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
033-738
[Cause] Received abnormal JBIG data.
[Remedy] No measure is required.
033-740
[Cause] The printing of the received fax document was interrupted.
[Remedy] No measure is required.
033-741
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
033-742
[Cause] An error occurred during fax transmission. This error may occur if the remaining
capacity of the machine's memory is 10% or less and Manual Send is used.
[Remedy] If this error was caused when using Manual Send, connect the line after storing the
document, and then send. If the error still is not resolved, delete unnecessary data from
the hard disk to free up disk space, and execute the operation again.
If the error persists, contact our Customer Support Center.
033-743
033-744
033-745
033-746
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. Try again. If the error still is not resolved, contact our Customer
Support Center.
033-747
[Cause] The job is temporarily suspended.
[Remedy] No measure is required.
033-749
[Cause] The machine will automatically recover and print the document.
[Remedy] No measure is required.
033-750
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. Try again. If the error still is not resolved, contact our Customer
Support Center.
033-751
[Cause] An activity report output occurred during the printer lockout duration. Outputting the
activity report was suspended because the machine was in the Sleep mode.
[Remedy] No measure is required because the machine will output the report after exiting the
Sleep mode.
Error Code Cause and Remedy

Fuji Xerox ApeosPort-V C3320 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-V C3320
Category	All in One Printer
Language	English