Fuji Xerox ApeosPort-V C3320 Administrator's Guide

Error Code
503
Problem Solving
14
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
[Cause] The data was automatically modified because it included an invalid parameter.
[Remedy] The printed image may be incomplete. Confirm with the sender whether the image has
a problem, or ask the sender to send the data again. When using the Internet Fax
Forwarding feature, confirm its condition with the e-mail recipient.
116-780
[Cause] There is a problem with the document attached to the received e-mail.
[Remedy] Check the attached document.
117-310
[Cause] An error occurred while scanning a document via WSD.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. Execute the same operation again.
117-311
[Cause] Data Security Kit is not attached correctly.
[Remedy] Insert Data Security Kit into the correct slot.
117-312
[Cause] An error occurred in the machine.
[Remedy] Contact our Customer Support Center.
117-319
117-320
117-321
117-322
117-323
117-324
117-327
117-329
117-331
117-332
117-333
117-334
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
117-343
[Cause] Probable causes are follows.
1)When [Image Log Control] on Tools is invalid and [Enabled] is set for [Transfer Image
Log], [Transfer Per Job Basis] is set for [Logs to Transfer].
2)When [Transfer Image Log] is invalid (the hard disk is not installed), [Log Transfer] is
set to be valid.
[Remedy] For 1, set other than [Transfer Per Job Basis] for [Log to Transfer].
For 2, install the hard disk to the machine, or set [Pause] for [Logs To Transfer].
117-347
[Cause] The life of the component which cannot be replaced is expired. The machine itself needs
to be replaced.
[Remedy] Contact our Customer Support Center.
117-348
[Cause] The unformatted SD card used in the other machine is installed.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
Error Code Cause and Remedy

Fuji Xerox ApeosPort-V C3320 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-V C3320
Category	All in One Printer
Language	English