Fuji Xerox ApeosPort-V C3320

Error Code
505
Problem Solving
14
121-326
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
121-333
[Cause] An error occurred between the machine and the device connected.
[Remedy] Confirm that the device is switched on, and then switch off the machine power, make
sure that the touch screen is blank, and switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
121-334
121-335
121-336
121-337
121-338
[Cause] An error occurred between the machine and the device connected.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
121-339
[Cause] An error occurred between the machine and the device connected.
[Remedy] Check the unit table for CoinKit. If an undefined item is included in the table, correct the
table. Switch off the machine power, make sure that the touch screen is blank, and then
switch on the machine power. If the error still is not resolved, contact our Customer
Support Center.
121-340
121-350
121-370
[Cause] An error occurred between the machine and the device connected.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
Error Code Cause and Remedy